Monday, July 18, 2011
Browse »
Home »
HP
»
Problem with hp designjet 750c
following problems hp designjet 750c
- Cutter cuts initial cut after power up but fails thereafter.
- Check cartridge path" error after overhaul, replaced belt and general clean. Carraige runs smooth when handled, when powered up up moves then juddersand gives the error message. Is this a problem with the encoder strip?
- 2 plotters with errors pointing towards friction on carriage path although they are both running smoothly on rails. Both sets of rails have been lubricated.
goodluck
Problem with hp designjet 750c
- Cutter cuts initial cut after power up but fails thereafter.
- Check cartridge path" error after overhaul, replaced belt and general clean. Carraige runs smooth when handled, when powered up up moves then juddersand gives the error message. Is this a problem with the encoder strip?
- 2 plotters with errors pointing towards friction on carriage path although they are both running smoothly on rails. Both sets of rails have been lubricated.
goodluck
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.