Thursday, July 5, 2012
Browse »
Home »
Modem
»
Installation Guide For The Linksys SPA2102
The Linksys SPA2102 adapter from Yak will include the following: the
Linksys SPA2102 analogue telephone adapter (ATA), an Ethernet cable and a
power adapter. You will need an analogue phone, a cable or DSL modem,
high speed Internet service and an Ethernet cable that should currently
connect your computer to your modem. In this configuration, if DSL is
being used it is highly recommended to use the modem in bridge mode and
use the ATA for PPPoE authentication. Configuration of the ATA in that
way is described in section C.
1. Disconnect the power from your cable or DSL modem and computer.
2. Connect one end of an Ethernet cable into the INTERNET port on the phone adapter (ATA) and the other end into your Cable/DSL modem.
3. Connect another Ethernet cable from your computer or router WAN/INTERNET port to the ETHERNET port on the phone adapter (ATA). If you are using a home router then connect your PC(s) to the free router ports using separate Ethernet cables..
4. Connect your analogue telephone to the LINE 1 port of the ATA Phone Adapter.
5. Connect the power to the Cable/DSL modem and power it up.
download Installation Guide For The Linksys SPA2102 here
Installation Guide For The Linksys SPA2102
1. Disconnect the power from your cable or DSL modem and computer.
2. Connect one end of an Ethernet cable into the INTERNET port on the phone adapter (ATA) and the other end into your Cable/DSL modem.
3. Connect another Ethernet cable from your computer or router WAN/INTERNET port to the ETHERNET port on the phone adapter (ATA). If you are using a home router then connect your PC(s) to the free router ports using separate Ethernet cables..
4. Connect your analogue telephone to the LINE 1 port of the ATA Phone Adapter.
5. Connect the power to the Cable/DSL modem and power it up.
download Installation Guide For The Linksys SPA2102 here
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.