Tuesday, July 3, 2012
Guide for installing the Boost sensor Audi A4/S4
The sensor may Boost uses the replacement sensor pod deflector pulse VDO. Designed with Pro-E to the best in fit and finish, giving you a plant like look and feel. Gauge 52 mm itself is mechanical VDO gauge gives a very accurate and reliable vacuum and boost readings. Pod gauge can be installed in any of the three Center holes. Install the Center vent installation illustrates
Step 1. Remove the vent holes. Pull the vent Assembly slowly with your fingers. Optionally, you can use a flat head screwdriver to carefully persuade chassis. There is a light wire that runs to the vents, be careful not to damage it during installation. Remove the rear flap. Binding on one side and unhook from another. Remove the hole where you want to install the sensor. Pod will fit into any of the three vent space.
Step 2. Snap-in under the sensor into the hole in the hull
You can adjust the angle of the pod by turning adjustment screws on the back.
Step 3. Attach the white nylon line to the sensor with the provided equipment. Before tightening the Assembly, make sure the row is fully seated and that the installation is oriented correctly, olive Using 1/2 inch and 1/4 inch wrenches, tighten the lamp, while making sure that the nylon line not retreated. Ferrule fitting will crimp on nylon when applied torque.
Step 4. Drill a small hole in the side of the duct vent Center for signal transmission lines. Place in a hole in the bottom left corner of the duct. 3/16 Inch ~ 3.5 mm in diameter is sufficient. If you want to run a transmission line later VDO gauge (for lighting), you may want to increase the hole to accommodate additional lines. Be sure to leave enough clearance so that he will not interfere when you install vents.
Download: http://www.sportcompactonly.com/manuals/Brand/APR/boost_gauge_pod.pdf
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.