Tuesday, July 3, 2012
Stern Pro-Mount Installation manual transmission Mount for Audi
This mountain pass will offer a reduction of motion transfer, transfer to faster and more accurate shifting and more power to the wheels. The following is an overview of how to install on a Audi A4 1 .8T with manual gearbox. Your car may have some subtle differences, but the general guiding principles remain the same.
Step 1. Raise the car and secure it with Jack stands. Never work under a vehicle, Hydraulic floor Jack is supported. Check the user's manual for the correct placement of the floor Jack and Jack stands.
Step 2. Define transmission mount. Some cars will have a 1, while most will have 2. They are just hanging from passing near the actuator shaft.
Step 3. Gently use a floor Jack to support the transfer of position and prevent it from shifting positions.
Step 4. With 13 mm socket, remove the 2 bolts. Depending on your specific model might be the heat shield around the mountain that must be moved. These heat shields held in place with small bolts and can be removed with a 10 mm wrench. Heat shields moved towards using 16 mm socket and wrench to remove the main centre of the bolt and nut.
Step 5. The Center bolt removed use the word Jack and carefully lift the transfer until the mount free to slip.
Step 6. Make sure the rear mount is assembled as shown below, and then position instead of the original mount. The provided big round Zinc plate will lie on top of the polyurethane. Reusing factory washer on top transmission bracket and lightly tighten the bolt area on the mountain pass. Now you can remove the transmission support. Apply loctite smaller flange bolts and tighten to 25Nm (18 ft. lbs.).
Step 7. Once you have a mountain of poorly run and let the car idle for a moment. After switching off the machine, tighten the bolt head Center Mount transmission up to 45-nanometer (33 ft lbs.). If you are installing 2 fastening on the vehicle, it is recommended that you install both mounts together at the same time.
Congratulations on completing the installation!
Download: http://www.purems.com/products/STB5TRMT03_Installation_Lo_Res.pdf
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.