Tuesday, July 3, 2012
Spec. Dock installation instructions Audi TT MK2 v2
Start the installation process by using your fingers to unsnap the cover on the side of the central console. This group will continue to unsnap the front of the vehicle. You do not need to remove it completely, just releasing these three clips will give you everything you need to route the cable spec. dock number.
Delete the original Insert ashtrays and run the spec. dock Integrated cable through the opening in the ashtray, good as shown.
You can easily grab the end of the cable through the hole on the side of the console, where you removed the earlier Group. Use degreaser high quality for example, denatured alcohol to clean inside the ashtray and remove the backing from the preinstalled double sided tape. Lower spec. dock position and press down firmly for ten seconds to ensure proper adhesion. In order to complete the connection of the spec. dock to your car audio system, refer to the manual included with the interface or auxiliary input devices you are using. Make sure you check out all the functionality to fully build the vehicle. The Assembly is the reverse of disassembly.
Download: http://www.tunertricks.com/guides/install_pdfs/audi/TT8J_install.pdf
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.